#1 September 11, 2015 3:05pm

JLV
Member
Registered: September 11, 2015
Posts: 2

Capacity Error Messaging

We set up a new form a couple days ago and someone has just contacted us after receiving an error message about capacity: http://www.architecture.org/chidesign-r … =%5BUNIQID

This has never happened before and we are unsure what the cause is. Please advise.

Thanks!

Offline

#2 September 11, 2015 3:09pm

timbuckingham
Administrator
From: Baltimore, MD
Registered: April 2, 2012
Posts: 970

Re: Capacity Error Messaging

The Form Builder extension allows you to set the maximum number of entries for your form. If you don't see it, toggle the "paid" checkbox for your form and it should reveal the "Limit number of entries" checkbox and the max limit for that form. You can then toggle the paid option back off after changing those settings.

Offline

#3 September 11, 2015 4:25pm

JLV
Member
Registered: September 11, 2015
Posts: 2

Re: Capacity Error Messaging

Thank you so much!

Offline

Board footer

Powered by FluxBB

The Discussion Forum is not available on displays of this size.