I think you have the wrong BigTree! This is a forum for the content management system, not the board manufacturer
]]>https://www.bigtreecms.org/forum/profile.php?id=102022-11-02T19:52:38Zhttps://www.bigtreecms.org/forum/viewtopic.php?pid=3757#p3757I have 3 new SKR Pro boards with TFT35 screens and have loaded a Bin file created by MPCNC V1 Engineering for Marlin 3D printers. They all act differently, and I need instructions to set them all to a fresh start with new flashing firmware. Then I can see if there are any errors and make corrections. All are set to 250000 baud, MPCNC firmware.bin, SD chip to flash, 2209 Drivers installed, no end stops connected. Should I format each chip and flash with a new copy of Marlin? Does anyone have a simple link of a Bin file? Thanks for your help. Rand]]>https://www.bigtreecms.org/forum/profile.php?id=21932022-11-02T19:29:29Zhttps://www.bigtreecms.org/forum/viewtopic.php?pid=3756#p3756